Pengendalian Kualitas Pada Mesin Injection Moulding Dengan Menggunakan Metode Mil Std 105d Dan Mil Std 414d Pada PT Cicor Panatec Batam

Authors

  • Erik Gowasa Universitas Putera Batam
  • Nofriani Fajrah Universitas Putera Batam

Keywords:

Quality Control, Statistics Process Control, Dissemination Tool, Quality

Abstract

Nowadays,the development of industry is increasing very rapidly. It can be knownasthe high competition between companies. Not only large and international scaled companies, small and medium-sized companies are also face the same challenges in the
global competition. Based on the preliminary study it is known that quality control is only done within the checking limit of the number of defective products produced without being evaluated or analyzed further. It is therefore necessary to analyze the defect product data generated and evaluate the results. The purpose of this study was to analyze the incompatibility of Comb 1 mm products. Map p is used in this study to analyze the number of defective products. Then a fishbone diagram is used to analyze the cause of product nonconformity. The results showed that there were no data within the control limits and most of the products were out of the median line of the P control chart. From the fishbone diagram found that human factors, machinery, raw materials, methods, and environment are the causes of mismatch comb products 1 mm. This research is expected to be useful for companies to improve product quality and customer satisfaction.

References

Amrina, E., & Fajrah, N. (2015).Analisisketidaksesuaian produk air minum dalam kemasan di PT Amanah Insanillahia. Analisis ketidaksesuaian produk air minum dalam kemasan di PT Amanah Insanillahia, 12(2), 99–115. Analisis Pengendalian Mutu Produksi Roti (Kasus PT. AC, Tangerang)

Henny Tisnowati , Musa Hubeis dan HartrisariHardjomidjojo. (n.d.). Conditioner, A. I. R., & Metode, D. (2017). Perancangan tangga yang ergonomis sebagai alat bantu pekerjaan service ac (air conditioner) dengan metode reba (rapid entire body assessment).

Ekonomi, F., & Lamongan, U. I. (2015). Analisis kapabilitas proses untuk pengendalian, X(2), 722–727.

Ekonomika, F., Bisnis, D. A. N., & Diponegoro, U. (2015). Analisis faktorfaktor penyebab kerusakan produk pada proses cetak produk.

Downloads

Published

2020-05-11

How to Cite

Gowasa, E. ., & Fajrah, N. . (2020). Pengendalian Kualitas Pada Mesin Injection Moulding Dengan Menggunakan Metode Mil Std 105d Dan Mil Std 414d Pada PT Cicor Panatec Batam. Prosiding Seminar Nasional Ilmu Sosial Dan Teknologi (SNISTEK), 2, 187–195. Retrieved from https://forum.upbatam.ac.id/index.php/prosiding/article/view/6432

Issue

Section

Articles

Most read articles by the same author(s)