ANALISIS PENGENDALIAN KUALITAS PRODUK OIL SEAL PADA PT DINAMIKA ANUGERAH
Kata Kunci:
FTA, Fishbone, SPCAbstrak
PT Dinamika Anugerah is a local company that produces oil seals and rubber molding for the needs of the automotive and non-automotive industries in Indonesia. The oil seal is a component on the engine part that functions to seal off the lubricant and prevent dirt and dust from entering the engine. The problem experienced by PT Dinamika Anugerah was the 33 NMB oilseal product which had a defective product exceeding the company's tolerance for defects, namely 0.5%. The number of Oil seal NMB products was 33 from September 2021 to August 2022, the percentage of defective products was 1.0290%. This research uses the method used is the Statistical Process Control (SPC) method to control quality control. As well as FTA to find loopholes to improve and minimize defective products and provide repair solutions with 5W + 1H and Based on the results of the analysis using Check Sheets it is known that the average defective caused by Spring 12 months material with a quantity of defective products is 1712 out of a total production of 166416 product is 1.0290%. When compared with the tolerance limit of the company's defective products (by 0.5%) this exceeds the tolerance limit so that the analysis of the causes of defective products and From the fishbone diagram above, it can be seen that defective Spring Pop out occurs due to several factors, namely coming from human/worker factors, production machines, working methods.
Referensi
Arjuna, P. G., & Muhammad, K. (2015).
Penerapanmetodesixsigmasebagai Upaya Pengendali Kualitas Produk Dengan Menggunakan Konsep Dmaic. Jurnal Rekayasa Teknologi Industi Hijau, 1, 1–10.
Bakhtiar, A., & Purwanggono, B. (2009). Analisis Implemenntasi Sistem Manajemen Kualitas Iso 9001 : 2000 Dengan Menggunakan Gap Analysis Tools. J@ti Undip: Jurnal Teknik Industri, IV(3), 163–170.
Bruder, U. (2015). Statistical Process Control (SPC). User’s Guide to Plastic, 7(November), 215–222. https://doi.org/10.3139/9781569905739.029
elsays, ricky handani, W. (2020). Statistical Process Control (Spc) Untuk Pengendalian Kualitas Produk Mebel Di Ud. Ihtiar Jaya. Bisma: Jurnal Manajemen, 6(1), 50. https://doi.org/10.23887/bjm.v6i1.24415
Hardiyanti, A., Mawadati, A., & Wibowo, A. H. (2021). Analisis Pengendalian Kualitas Proses Penyamakan Kulit Menggunakan Metode Statistical Process Control (SPC). INDUSTRIAL ENGINEERING JOURNAL of the UNIVERSITY of SARJANAWIYATA TAMANSISWA, 5(1), 41–47. https://jurnal.ustjogja.ac.id/index.php/IEJST/index
Himawan, A. (n.d.). PENGENDALIAN KUALITAS STATISTICAL PROCESS CONTROL PRODUK GENTENG DI UKM SUPER SOKA JEPARA.
Ratnadi, R., & Suprianto, E. (2016). Pengendalian Kualitas Produksi Menggunakan Alat Bantu Statistik (Seven Tools) Dalam Upaya Menekan Tingkat Kerusakan Produk. Jurnal Indept, 6(2), 11.
